SHINE VERSION OF OUR VERSATILE GENERAL PURPOSE GLAZE
Fast drying, smooth, not too powdery when dry. Fire items once touch dry. Takes about 5 minutes to become touch dry.
Glaze best firing range 1020 to 1080 Degrees C. Check recommended firing range for your bisque to ensure compatibility. Cone 06 to 05. Best test is Bullers ring size 14 to 18 (old rings 3 to 7). Soak for 30 minutes to 1 hour to achieve a very shiny finish. Burns clear and smooth over black.
Bisque Direct bisque is best fried to 1020 - 1080 Degrees C. The higher the firing the stronger the items.
Dip quickly with a fast smooth action. Shake a few times over the dipping bucket to remove excess glaze. Hold till glaze stops moving then place on bench to dry. Glaze has a relatively fast drying time - Dries in less than 5 minutes. Items can be fired immediately after dipping.
Viscosity Cup 44ml Stainless Steel - Target reading is 21 seconds. Shorter time means glaze is to thin. More binder required or too much water has been added. See Weight Test below. Longer time glaze has evaporated and a small amount of water should be added.
Glaze Weight Test. Take an accurate measuring cylinder and weigh the dipping glaze. Target is 1380grams per litre (1000ml). You may use say a 1/2 litre (500ml) measuring cylinder for a reading of 690grams.
Material Safety Data Sheet available on request. MSDS.
DO NOT ALLOW GLAZE TO FREEZE. This will kill off the preservative and allow bacteria in to feed on the binder - glaze will start to smell really bad. This is common to all dipping glazes.